04-20-2015 08:32 PM - edited 03-05-2019 01:17 AM
Hi, I'm a Korean engineer.
Today, I have a trouble about backbone supervisor module WS-SUP720-3B.
I tested module WS-X6148A-GE-TX with SUP720-3B.
But, in the CLI, this sentense came out ... "not support slot 2, 3."
(slot 2,3 = WS-X6148A-GE-TX)
So I read a datasheet, but WS-X6148A-GE-TX was not listed anywhere.
(http://www.cisco.com/c/en/us/support/docs/switches/catalyst-6500-series-switches/69583-ptn.html)
So, I am wondering if WS-X6148A-GE-TX is not supported by SUP720-3B? right?
plz contact me...
Regards,
04-20-2015 10:27 PM
Can you post the complete output to the command "sh module"?
04-20-2015 11:03 PM
04-21-2015 12:30 AM
It seems that WS-X6148A-GE-TX is supported with Supervisor Engine 720 since IOS release 12.2(18)SXF, so SXE (which your SUP seems to be running) won't do - see section "Software support" of Table 2-10 here:
http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/hardware/Module_Installation/Mod_Install_Guide/6500-emig/02ethern.html#wp1042813
04-21-2015 02:41 AM
Wow...
Thank you so much!
It is so helpful to me!
04-21-2015 02:49 AM
WOW !
Thank you so much!! Leo Laohoo, Iulian Vaideanu !
Ah,,, now I understand all your opinion^^
Have a nice day~
04-21-2015 01:10 AM
I agree. You need to upgrade the IOS of the supervisor card.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: