05-09-2017 02:30 AM - edited 03-05-2019 08:29 AM
Hi,
Does anyone know how pfr inject routes to the border routers in IWAN solutions. I know it measures the performance of the channels using IP SLA Jitter probes and keeping a table based on traffic-classes. After traffic comes it chooses the best exit interface based on those information and route the traffic through the preferred path defined or fall back to the other path if it exceeds the policy threshold values. I need to know how master control tells to border routers to use this path over eigrp learnt routes in the routing table.
Thanks,
05-09-2017 05:10 AM
My experience with PfR predates the later PIRO variants, but assuming it works similar as it did, the MC injects routes on the border routers it manages, basically overriding whatever the existing routing is for particular destinations.
05-11-2017 11:31 AM
Hello.
PFRv3 does not inject routes into routing table. Instead PFRv3 injects itself into CEF path, so it may override FIB.
If you are asking about decision enforcement, it works like following:
Best regards,
09-14-2017 03:37 AM
Hi Vasilii
Is there a command to view the route overrides that IWAN/PfRv3 has implemented?
04-01-2021 07:38 AM
it is :
show ip route overrides pfr
some older implementation used dynamic route-maps with pbr though.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide