cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
380
Views
0
Helpful
2
Replies

How to find IP address for Route-1 and Route-2?

getaway51
Level 2
Level 2

Hi,

 

I tried search for Route_1 & Route_2 in sh run but there is none.

Where can i find IP for Route_1 & Route_2? Ping Route_1 & Route_2 also cant.

 

ip route 0.0.0.0 0.0.0.0 Vlan10 172.30.219.81 name Route_1
ip route 0.0.0.0 0.0.0.0 Vlan10 172.30.219.82 name Route_2

2 Replies 2

hadi riyahiyan
Level 1
Level 1
if you want to find a special configuration in sh runn you can use these commands:
#sh runn | sec ip route
OR
#sh runn | inc 172.30.219.81

Hello

Probably this next-hop isn't directly connected as such it could be a recursive static route also ping may be disabled for these two prefixes or just ghost entries not required anymore.

sh ip route connected
sh ip int brief
sh ip arp 172.30.219.81
sh ip arp 172.30.219.82
traceroute 172.30.219.81 numeric
traceroute 172.30.219.82 numeric


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco