How to verify optical power level in a SFP inserted in a cisco 3800

[william.tituana]

Hi all,

I have a Cisco3800 with IOS Version 12.3(14)T2 and I have an HWIC-1GE-SFP module inserted on it.  

I need to know if there is a command to verify optical power level in this module inserted in the Cisco 3800 router?

Something similar to the following command that I can execute in an Cisco ASR9K:

show controllers Te0/0/0/1 phy | i Rx

Thanks in advance for your answers.

[Ivan Shirshin]

Hi William,

It is "show interfaces ... transceiver detail" command.

Kind Regards,
Ivan Shirshin

**Please grade this post if you find it useful.

[william.tituana]

Hi Ivan,

Thanks for your answer but that command its not available for that interface.

[paolo bevilacqua]

That is DOM. It's only supported on certain modules, and likely not supported on the 3800 at all.

http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_8031.html

[Ivan Shirshin]

Paolo, you are right, DOM is not supported on this HWIC:

		Minimum Software Release Required
Platform	Switch or Module	Transceiver Module	DOM Support	Cisco IOS Release

HWIC-1GE-SFP

GLC-T GLC-SX-MM GLC-LH-SM GLC-ZX-SM CWDM SFP GLC-SX-MMD GLC-LH-SMD

—

12.3(8)T4

The card with DOM support is EHWIC-1GE-SFP-CU and it is supported on ISR-G2 only.

DOM support provides optical levels, including such commands as:

     show int transceiver detail

     show int transceiver

     show controller | incl Diag

Kind Regards,
Ivan Shirshin

[santoshautade]

I am facing this issue while I am using following comand on 3900 series router which comand should I Use to check optical power on this router ????

DLHIPDNGAMR001#sh interfaces Gi0/1/0 transceiver detail
Module 0 doesn't support DOM

DLHIPDNGAMR001#sh interfaces Gi0/0 transceiver detail
Module 0 doesn't support DOM

[hortegaf@hotmail.com]

Hi William:

Try this
show hw-module subslot 0/0 transceiver 1 status

[Sameer T]

Thanks bro...

works well

[Peterson Dorcelus]

On the Catalyst 9300 you can perform.

# show interfaces transceiver detail.

This command will show the temperature, voltage, current, decibel levels, and thresholds.