cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
374
Views
0
Helpful
1
Replies

HWIC-1FE as trunk

sumesh_un
Level 1
Level 1

I am not able to configure HWIC-1FE as a trunk port.However the switchport command is not available in its interface configuration mode.

any suggestions?

1 Reply 1

Calin C.
Level 5
Level 5

Hello!

HWIC-1FE is a router interface.In which device are you using it? You cannot configure a L3 port with swichport command.

Use subinterface on that module with "encapsulation dot1q 'vlan_number'" where the vlan_number is configured on the switch (if you connect the router to a switch) and allowed by the trunk config.

Please tell me if you understand or give more details.

Good luck!

Calin

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: