HWIC-4SHDSL CO Pair Groups

[mike_cynnex]

Wondered if anyone saw any issues with this or knows if it is or is not supported.

Plan on a 2921 with 1 HWIC-4SHDSL as the CO end.

I'd like to use 4 1-pair groups to connect to 4 respective CPE 888's.

Thanks

[paolo bevilacqua]

I think you can configure only 2 dsl-group, so 2 remote sites.

http://www.cisco.com/en/US/partner/docs/routers/access/interfaces/software/feature/guide/shdslfm.html

[mike_cynnex]

Thanks for the reply.

Per the following doc, 4 dsl-groups or "lines" can be configured.

http://www.cisco.com/en/US/docs/routers/access/interfaces/software/feature/guide/shdslfm.html

I know the HWIC-4SHDSL will support at least one 2 or 4 wire dsl-group as a CO...we tested it.

What I'm unsure of, is if there is anything that would prevent the use of the remianing pairs in additional dsl-groups, also in the CO mode.

I would test it, but the hardware has been returned to the vendor.