i'm trying to install the NPE-G2 on Cisco Router 7206VXR but the keying post on the NPE-G2 stock in the end of the chassis.
Anybody have this problem before please help ASAP
Could you please capture the router booting sequesnce and paste it here.
I can't start the router because I couldn't insert the NPE-G2 into the slot because the keying post as illustrated in the attachment file. And you know the NPE-G2 is the main controller of the router.
are trying to insert the NPE-G2 in place of the current NPE ?
Be aware that in same side of PAs there is the I/O controller
verify that the chassis is 7206VXR and not a C7206.
boot with the old NPE and issue
and check the chassis type
Hope to help
thank you so much for your help.
i notice that there is two NPE-G2 version one with keying post and one without and the chassis that i have don't support the new one and i think i should get the older version of NPE-G2 i don't think that i have another choice.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: