cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1180
Views
0
Helpful
4
Replies
Highlighted
Beginner

I want to configure BGP on 3560 Switch, But error " Protocol not in this image"

Dear Experts,

i want to configure BGP on our old 3560 Switch i have tried with all suggested IOS  (ADVIPSERVICES, IPSERVICES, IPBASE) but while configuring BGP it showing 

Error " Protocol not in this image" Please help me to get resolve the same..

Is any licence is required to use BGP on old switches.

Please provide the solution...

Manish Pandey

7739449638

4 REPLIES 4
Highlighted
Hall of Fame Guru

BGP should work with IP

BGP should work with IP Services as a minimum.  

Have you enabled routing - "ip routing". 

Jon

Highlighted
Beginner

Hi Jon,

Hi Jon,

Thanks for this discussion.

Yes i have enabled IP routing in L3 switch. Model- WS-C3560G-24PS-S 

I have tried the same with following IOS but issue persist. Please help me to resolve this issue.

Tried IOS-           c3560-advipserviesk9-mz.122.46.SE.bin

Tried IOS-            c3560-ipservicesk9-mz.122.55.SE11.bin

Current IOS-       c3560-ipbasek9-mz.122-55.SE10.bin

Thanks & Regards,

Manish Pandey

7739449638

Highlighted
VIP Mentor

Hello,

Hello,

check if the below command is available:

3560(config)#license boot level ipservices

Highlighted
Enthusiast

If "sh boot" outputs

If "sh boot" outputs advipservices it doesn't necessarily mean that the switch is actually running that image (only that it has been configured to boot it with the next reload) - did "sh ver" say advipservices too?

ipbase won't do BGP - make sure the switch is actually running an ipservice image and you should be able to configure BGP...