I'm in the process of implenting SSH required logins on our 7609 and 6509 Core routers in our network. I'm curious about the processor load when implenting this technology. Is it possible it will cause any adverse affects?
Any suggestions -
cisco WS-C6509-E (R7000) processor (revision 1.2) with 983008K/65536K bytes of memory.
Processor board ID
SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache
Last reset from s/w reset
1 SIP-200 controller (2 POS).
54 Virtual Ethernet interfaces
96 FastEthernet interfaces
52 Gigabit Ethernet interfaces
2 Packet over SONET interfaces
1917K bytes of non-volatile configuration memory.
8192K bytes of packet buffer memory.
Cisco CISCO7609-S (M8500) processor (revision 1.0) with 851968K/65536K bytes of memory.
BASEBOARD: RSP720
CPU: MPC8548_E, Version: 2.0, (0x80390020)
CORE: E500, Version: 2.0, (0x80210020)
CPU:1200MHz, CCB:400MHz, DDR:200MHz,
L1: D-cache 32 kB enabled
I-cache 32 kB enabled
Last reset from power-on
33 Virtual Ethernet interfaces
100 Gigabit Ethernet interfaces
3964K bytes of non-volatile configuration memory.
