I just swapped out my VG200 for a 2801 for our voice gateway. I've noticed that our slip secs are steadly increasing. Have I missed something in my configuration. Any help would be appreciated.
network-clock-participate wic 3
isdn switch-type primary-dms100
controller T1 0/3/0
framing esf
linecode b8zs
cablelength short 110
pri-group timeslots 1-24
interface Serial0/3/0:23
no ip address
encapsulation hdlc
no ip route-cache cef
no ip route-cache
no logging event link-status
isdn switch-type primary-dms100
isdn incoming-voice voice
isdn bchan-number-order ascending
show controllers t1
T1 0/3/0 is up.
Applique type is Channelized T1
Cablelength is short 110
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version info Firmware: 20080918, FPGA: 13, spm_count = 0
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (595 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
337 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
337 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
Total Data (last 1 15 minute intervals):
0 Line Code Violations, 0 Path Code Violations,
511 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,
511 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs
