Inspecting ACL hits on ASR1002

[anthony.brewley]

Hi

I'm aware ACL's are handled in hardware on the ASR platform but wondered if there was any way to inspect how many hits we get on each line of an ACL on the ASR, I can't seem to find a command to do this.

Using LOG is not possible due to the large number of hits.

thank you

Anthony

[Amit Aneja]

Anthony,

This is a platform limitation & there isn't any command that would show you the ACL hits.
This not only applies to the ACL on the interface, but to the ACLs used in PBR, QOS etc.

I don't know of a command that would show you the hits in hardware for each ACL.
Commands do exist to check whether a specific traffic hit PBR or QOS in hardware.

Regards,
Amit Aneja

[anthony.brewley]

thats disappointing but thanks for the quick reply, Amit.

Very much appreciated.

regards

Anthony