Hi,
I found the following output from my interface showing high MTU values & RX/TX values causing high latency :
Tunnel1190 is up, line protocol is up
Hardware is Tunnel
Description: "ABC"
Internet address is 1.1.1.1/29
MTU 17886 bytes, BW 100 Kbit/sec, DLY 50000 usec,
reliability 255/255, txload 255/255, rxload 255/255
Encapsulation TUNNEL, loopback not set
Keepalive not set
Tunnel source 1.1.1.1, destination 2.2.2.2
Tunnel protocol/transport IPSEC/IP
Tunnel TTL 255
Tunnel transport MTU 1446 bytes
Tunnel transmit bandwidth 8000 (kbps)
Tunnel receive bandwidth 8000 (kbps)
Tunnel protection via IPSec (profile "ipsec-profile-vti")
Last input never, output never, output hang never
Last clearing of "show interface" counters 6w3d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 152776
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 204000 bits/sec, 33 packets/sec
5 minute output rate 272000 bits/sec, 121 packets/sec
176521998 packets input, 3198683225 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
162077114 packets output, 3749387952 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
Please help me to resolve this.
Regards,
Ninad Thakare
