cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1203
Views
0
Helpful
4
Replies
anjaneesh
Beginner

IOS 12.4(T) support BGP ??

I had a Cisco 2811 router whose ios image is ios 12.4(T) with advanced security. This image doesn't support BGP.

error message it gives when I m trying to configure BGP is::

Protocol not in this ios image.

4 REPLIES 4
williamwbishop
Beginner

BGP is supported on both older hardware and older ios versions. Most likely the image you have applied just doesn't support bgp. You will need an image that does. If you will post your show ver we will know more about what your ios version supports.

anjaneesh
Beginner

This is the show version output

ROM: System Bootstrap, Version 12.3(8r)T7, RELEASE SOFTWARE (fc1)

ghaziabad uptime is 23 minutes

System returned to ROM by power-on

System restarted at 09:51:49 UTC Mon Aug 22 2005

System image file is "flash:c2800nm-advsecurityk9-mz.124-1a.bin"

This product contains cryptographic features and is subject to United

States and local country laws governing import, export, transfer and

use. Delivery of Cisco cryptographic products does not imply

third-party authority to import, export, distribute or use encryption.

Importers, exporters, distributors and users are responsible for

compliance with U.S. and local country laws. By using this product you

agree to comply with applicable laws and regulations. If you are unable

to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found

at:

http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to

export@cisco.com.

Cisco 2811 (revision 53.51) with 249856K/12288K bytes of memory.

Processor board ID FHK0931F01W

2 FastEthernet interfaces

6 Serial(sync/async) interfaces

4 ISDN Basic Rate interfaces

1 Virtual Private Network (VPN) Module

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0x2102

Hi anjaneesh,

Sorry to say the code you are running does not support BGP. It do support EIGRP, OSPF, RIp but not BGP.

Check this link

Open this link first

1) http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

Then click on

2) Search by Software/Image Name/Product Code/Platform

Then enter your full image name under section Image Name

and serach it will give u 3 optiosn for router and selct your router and it will show you the features it supports and it doe snot support BGP.

HTH

Ankur

anjaneesh
Beginner

Thankx Ankur

That solved my problem.