11-08-2013 04:20 AM - edited 03-04-2019 09:31 PM
I'm in the process of installing four Cisco 4451-X routers and see that the object-group network command is missing?! There is an object-group security but no network.
Will this be coming back or am I missing something?
11-13-2013 07:00 AM
Did you get any resolution to this problem as I have the same issue
11-13-2013 07:02 AM
Nothing at all. No one seems to have an answer. I'm going to call my Cisco SE later today.
11-13-2013 07:06 AM
Yep I am going to raise with our distributor
09-21-2014 10:14 PM
Hello,
I am having the same problem with IOS asr1001-universalk9.03.09.01.S.153-2.S1.bin, but I could figure out on another ASR1001 that the command is available in this very old IOS-Version: asr1001-universalk9.03.06.00.S.152-2.S.bin
So anyway - can You confirm that the "object-group network" command ist available on Version 03.12.01.S ?
Thanks,
Stefan
09-21-2014 11:16 PM
Stefan,
This cmd is again availabe from ;
Release 4.3.1
To configure a network object group, and to enter the network object group configuration mode, use theobject-group network command in the global configuration mode. To de-configure the network object group, use the no form of this command.
object-group network { ipv4 | ipv6 } object-group-name
no object-group network { ipv4 | ipv6 } object-group-name
ipv4 | Configures the operation state of an IPV4 network object group. |
ipv6 | Configures the operation state of an IPV6 network object group. |
object-group-name | Name of the object-group. |
08-22-2014 12:18 AM
How to Solve a Problem?
Please help.
08-22-2014 06:11 AM
I'm late to update this post but it looks like the command is back in Cisco IOS XE Software, Version 03.12.01.S - Standard Support Release.
object-group network SRS_Internal
host 10.138.244.11
host 10.138.244.12
08-22-2014 08:05 AM
Thank's for your reply campbech1 !
But my version:
Cisco IOS XE Software, Version 03.10.02.S - Extended Support Release
Cisco IOS Software, ISR4400 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.3(3)S2, RELEASE SOFTWARE (fc3)
What's wrong???
08-22-2014 08:07 AM
I don't believe it was supported until version 3.12 and you're on 3.10 currently. You'll need to complete a software upgrade.
08-22-2014 08:21 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide