cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
664
Views
0
Helpful
0
Replies
Highlighted
Beginner

IP NAT Route-map

Hello,

I have just upgraded my 1841 from 12.4.24T1 to 12.4.24T4

after the upgrade the following statement does not seem to work


ip nat inside source route-map VPN_EXCLUDE pool USERS overload

the route-map is configured

route-map VPN_EXCLUDE permit 10
match ip address VPN_NONAT
match interface Dialer0

when I change the statement to

ip nat inside source list VPN_NONAT pool USERS overload

it works fine, but when I use route-map it does not make any translations.

I want to use route-map because I have a dual ISP configuration.

I tried also to upgrade to 15.1.3T but there are no differences, this NAT statement still does not work as it was working with 12.4.24T

Everyone's tags (5)
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards