IP SLA IS NOT WORKING IN c2600-ik9s-mz.122-46a.bin.

[Sigeesh Sivadasan]

Dear Team,

We have Cisco2621XM router,  where in the below IP SLA is not supporting. Refering the Cisco feature navigator, understood that the below features will support c2600-ik9s-mz.122-46a.bin. But i am not able to execute IP SLA command in config mode.

The below are the features captured from Cisco feature navigator and the same are not supporting in c2600-ik9s-mz.122-46a.bin IOS.

IP SLAs - DHCP Operation
IP SLAs - Distribution of Statistics
IP SLAs - DLSW+ Operation
IP SLAs - DNS Operation
IP SLAs - FTP Operation
IP SLAs - History Statistics
IP SLAs - HTTP Operation
IP SLAs - ICMP Echo Operation
IP SLAs - ICMP Path Echo Operation
IP SLAs - One Way Measurement
IP SLAs - Reaction Threshold
IP SLAs - Scheduler
IP SLAs - SNA LU2 Echo
IP SLAs - SNMP Support
IP SLAs - TCP Connect Operation
IP SLAs - UDP Echo Operation
IP SLAs - UDP Jitter Operation

[Calin C.]

Does it work with rtr command instead of ip sla ?

Cheers,

Calin

[Sigeesh Sivadasan]

Hi Calin,

No, None of the commands are working. I have attatched the o/p.

Thanks,

Sigeesh

[Calin C. · Accepted solution]

I've chosen the same features for IP SLA with Features Navigator and the lowest IOS version that support what you need it's 12.3, Enterprise features set.

See attachement.

I have here a 2600 with c2600-i-mz.123-1.bin, and:

(config)#rtr ?
  <1-2147483647>          Entry Number
  key-chain               Use MD5 authentication for RTR control message
  low-memory              Configure low water memory mark
  reaction-configuration  RTR Reaction Configuration
  reaction-trigger        RTR trigger assignment
  reset                   RTR Reset
  responder               Enable RTR Responder
  restart                 Restart an active entry
  schedule                RTR Entry Scheduling
  slm                     Service Level Management

I think you have to upgrade.

Calin

[Sigeesh Sivadasan]

Hi Calin ,

The configuration is fine after IOS upgrade. Thanks for your inputs.