IP SLA reaction-configuration for Packet Loss using ICMP jitter
I have a situation wherein I need to ping a non-cisco device at a rate of 200 pings every 5minutes i.e. send 200ping packets at the start of every 5th minute. But the main challenge is I need to configure IP SLA to generate trap or threshold exceeded syslog when the packet loss goes above 6% and threshold cleared log when the packetloss goes under 5%. I have tried it as below:
ip sla 1 icmp-jitter 220.127.116.11 source-ip 18.104.22.168 num-packets 200 frequency 300 ip sla schedule 1 life forever start-time now
I am unable to understand how would the threshold-value and threshold-value work together. I don’t want that when the router starts the ping of 200 and if it sees packets from 50 to 56 drop to generate log. Rather I want it to complete the ping of and then determine if 6/200 crosses the threshold or not.
Once Cisco DNA Center has provisioned the SD-Access devices to sites, the SD-Access fabric can be created. In the Cisco DNA Center UI, navigate to Provision > Fabric. This is where you create and manage your fabric domains and transits.]
Provision Discovered Devices
On the Cisco DNA Center UI, navigate to Provision page
Select the following devices and provision all the devices to Floor-1. During the provision workflow, Cisco DNA Center can only provision devices of similar family. We wi...