Hi Dear Experts ,
I have 2 cisco routers and 2 public IP Address for wan link fail-over. Now ,I would like to configure IPsec VPN failover and device failover . When i check some posts, they are configuring with same public IP range and HSRP for IPSec VPN failover . They configure HSRP Vritual IP Cisco routers' WAN site .
Can i configure IPsec site to site VPN fail-over with different Public IP address in Cisco router? Please give me suggestion . Thanks .
the public IP addresses need to be configured on the ISP facing interfaces. HSRP is configured on the LAN interfaces. Have a look at the doc below:
Hi Dear Georg Pauwen ,
Thanks for your reply . Please kind check the attached image that is our requirement design . Please give me advice that design is possible to configure IPSec Tunnel fail over . Thanks .