12-07-2018 02:49 AM - edited 12-07-2018 03:01 AM
Hi Dear Experts ,
I have 2 cisco routers and 2 public IP Address for wan link fail-over. Now ,I would like to configure IPsec VPN failover and device failover . When i check some posts, they are configuring with same public IP range and HSRP for IPSec VPN failover . They configure HSRP Vritual IP Cisco routers' WAN site .
Can i configure IPsec site to site VPN fail-over with different Public IP address in Cisco router? Please give me suggestion . Thanks .
HM
12-07-2018 04:36 AM
Hello,
the public IP addresses need to be configured on the ISP facing interfaces. HSRP is configured on the LAN interfaces. Have a look at the doc below:
12-09-2018 07:12 PM
Hi Dear Georg Pauwen ,
Thanks for your reply . Please kind check the attached image that is our requirement design . Please give me advice that design is possible to configure IPSec Tunnel fail over . Thanks .
HM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide