Is there any Cisco device that supports Mask assignment for IPv6 WCCP? I've found documents on CCO that contradict each other and none of the hardware I have access to, with latest code, shows Mask being available for IPv6.
From a 4321 with the latest 16.6:
R1#show wccp capabilities
WCCP Platform Capability Settings
Capability IPv4 Setting IPv6 Setting
Supported forwarding methods GRE & L2 GRE & L2
Supported return methods GRE & L2 GRE & L2
Supported assignment methods Hash & Mask Hash
Accelerated forwarding methods GRE & L2 GRE & L2
Accelerated return methods GRE & L2 GRE & L2
Accelerated assignment methods Hash & Mask Hash
Accelerated Mode CLI On, CLI Disabled On, CLI Disabled
Supported redirection types Input & Output Input & Output
Check Outbound ACL CLI CLI Enabled CLI Enabled
Check All Services CLI CLI Enabled CLI Enabled
Closed Service Suport Supported Supported
VRF Support Supported Supported
Supported service groups 256 256
Assuming there are no other requirements, is there any Cisco router or switch model that has IPv6 mask assignment support?
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access for Distributed C...
Dear All, When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28X...
Whether you're attending VMworld 2019 on-site or from afar, read the latest on the key themes to expect. They are also the key themes for IT management today, from software defined everything to cloud and automation to IoT and edgecomputing : http:...