Solved: Is firmware still available for EOL routers? Cisco 7120-T3 Version 12.1(5)T10

badassmexican · ‎12-20-2018

I'm trying to enable SSH and secret but I seem to be missing some commands.

I set the domain-name to see if that would enable it but still no go.

I don't seem to have the crypto command available.

The secret command isn't available when I try to create a user only password.

Is this a version issue and can I upgrade the firmware or am I missing something that needs to be done to enable it?

I have a Cisco 7120-T3 Version 12.1(5)T10

Thanks,

Joel

pieterh · ‎12-21-2018

access to software is limited by contracts, so IF available, you may not be able to access it.
try "show version" or "dir" to determine what image you are running
if there is ipbase, instead of ipbasek9 in the name, you may be running the non-crypto version

View solution in original post

pieterh · ‎12-21-2018

access to software is limited by contracts, so IF available, you may not be able to access it.
try "show version" or "dir" to determine what image you are running
if there is ipbase, instead of ipbasek9 in the name, you may be running the non-crypto version

badassmexican · ‎12-21-2018

I don't seem to have anything with ipbase. So maybe that means that SSL is out.

Router#sh version

Cisco Internetwork Operating System Software

IOS (tm) EGR Software (C7100-IS-M), Version 12.1(5)T10, RELEASE SOFTWARE (fc2)

TAC Support: http://www.cisco.com/tac

Compiled Tue 07-Aug-01 20:23 by ccai

Image text-base: 0x60008960, data-base: 0x61620000

ROM: System Bootstrap, Version 12.0(5r)XE2, RELEASE SOFTWARE (fc1)

BOOTFLASH: EGR Software (C7100-BOOT-M), Version 12.0(5)XE7, EARLY DEPLOYMENT RE)

Router uptime is 20 hours, 36 minutes

System returned to ROM by reload at 14:00:10 PST Thu Dec 20 2018

Running default software

cisco 7120-T3 (EGR) processor (revision A) with 57344K/73728K bytes of memory.

Processor board ID 11509649

R527x CPU at 225Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache

Last reset from power-on

Bridging software.

X.25 software, Version 3.0.0.

2 FastEthernet/IEEE 802.3 interface(s)

1 Serial network interface(s)

125K bytes of non-volatile configuration memory.

46976K bytes of ATA PCMCIA card at slot 1 (Sector size 512 bytes).

8192K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2102

badassmexican · ‎12-21-2018

I see these when I do dir

Router#dir bootflash:

Directory of bootflash:/

1 -rw- 2814896 May 15 2000 08:35:26 c7100-boot-mz.120-5.XE7

Router#dir /all disk1:

Directory of disk1:/

3 -rw- 9188664 Feb 22 2003 00:24:06 c7100-is-mz.121-5.T10