cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
100
Views
5
Helpful
2
Replies
Highlighted
Explorer

is this combination is correct c7606 SIP-400 + SPA-1X10GE + SPA-2XOC12

Hello,

Is this combination is correct on a c7606 SIP-400 + SPA-1X10GE + SPA-2XOC12

My IOS is c7600rsp72043-advipservicesk9-mz.152-4.S2.bin

When I've inserted the SPA-1X10GE then it says

%SIPSPA-4-MAX_BANDWIDTH_NS: Total SPA bandwidth exceeds line card capacity, installed combination of SPA interfaces is not supported

Mod  Sub-Module                  Model              Serial       Hw     Status
---- --------------------------- ------------------ ----------- ------- -------
  1  Distributed Forwarding Card WS-F6700-DFC3CXL   SALxxxxxxxxxxx  1.6    Ok
 2/1 2xOC12 POS SPA              SPA-2XOC12-POS     SALxxxxxxxxxxx 1.0    Ok
 2/2 1x10GE XFP SPA              SPA-1X10GE-L-V2    SALxxxxxxxxxxx 1.5    AdmnDown

Mod  Online Diag Status
---- -------------------
  1  Pass
  2  Pass
 2/1 Pass
 2/2 Not Applicable
  5  Pass

Regards,

Antra

Everyone's tags (1)
2 REPLIES 2
VIP Advisor

http://www.cisco.com/en/US

http://www.cisco.com/en/US/products/hw/routers/ps368/module_installation_and_configuration_guides_chapter09186a0080440317.html

Troubleshooting Oversubscription on the Cisco 7600 SIP-400

As of Cisco IOS Release 12.2(18)SXF, when using the Cisco 7600 SIP-400 with the 2-Port Gigabit Ethernet SPA or the 1-Port OC-48c/STM-16 ATM SPA, consider the following oversubscription guidelines:

•The Cisco 7600 SIP-400 only supports installation of one 1-Port OC-48c/STM-16 ATM SPA without any other SPAs installed in the SIP.

•The Cisco 7600 SIP-400 supports installation of up to two 2-Port Gigabit Ethernet SPAs without any other SPAs installed in the SIP.

•The Cisco 7600 SIP-400 supports installation of any combination of OC-3 or OC-12 POS or ATM SPAs, up to a combined ingress bandwidth of OC-48 rates.

•The Cisco 7600 SIP-400 supports installation of any combination of OC-3 or OC-12 POS or ATM SPAs up to a combined ingress bandwidth of OC-24 rates, when installed with a single 2-Port Gigabit Ethernet SPA.

Configurations on the Cisco 7600 SIP-400 with an unsupported aggregate SPA bandwidth greater than OC-48 rates generates the following error message:

SLOT 3: 00:00:05: %SIPSPA-4-MAX_BANDWIDTH: Total SPA bandwidth exceeds line card capacity 
of 2488 Mbps

Explorer

Thank you for your answer.

Thank you for your answer.

So if the limit is OC-48(2Gbps), then why it support the 10Gigabits.

What should be the SIP used if we want to use this 10Gigabits?

Otherwise what should be done if we want to add another STM-16.

Regards,

Antra

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards