06-21-2005 02:08 PM - edited 03-03-2019 09:51 AM
I have set up a PPPoE ADSL connection on a PIX. I needed user name, password and the IP address teh ISP gave me. The default gateway comes from teh ISP using the PPPOE SETROUTE statement.
How I am putting in a 2811 to replace the PIX. The connection, like before, is using an ethernet port. However, I do not see any commands that get teh default gateway from the ISP during the loggon procedure. How is this configured?
As well, when I configure the outside interface, it does not allow a /32 mask (the PIX does). I seem to be forced to create a subnet where there is none.
I have been using the SDM program to configure it. Suggestions?
06-21-2005 07:47 PM
Hey Jcowtan post ur config and i will make changes for you
06-22-2005 06:35 AM
06-24-2005 08:04 AM
We got it working. I cleared out the config and started from scratch and the default route was found.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: