Hi There is no actual defined size for jumbo frames like an RFC that im aware of anwyay, its never been fully tied down to one particular size but most vendor will agree around 9000 just set each side to 9000 should be ok , you dont have to use the max allowed , and 9ks as below can do per interface too unlike 5ks where its global only
(config)# int e1/16 (config-if)# mtu ? <576-9216> Enter MTU
(config-if)# mtu 9000 # sh int e1/16 Ethernet1/16 is down (XCVR not inserted) admin state is down, Dedicated Interface Hardware: 1000/10000/25000 Ethernet, address: 2c4f.5283.3efd (bia 2c4f.5283.3f0d) MTU 9000 bytes, BW 25000000 Kbit, DLY 10 usec
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2...
Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs...
good morning I have this report from users, saying that they encounter connection issue only when they are wired , but the wireless I fine. both connection are using the same path to the internet ...please advised a troubleshooting plan.
Enterprise Switching Business Unit is glad to announce Beta release 16.12.3 for all Catalyst 9200/9300/9400/9500/9600. This release is made available to allow users to test, evaluate and share feedback before General Avail...