08-29-2012 01:44 AM - edited 03-04-2019 05:24 PM
Is l2tp possible between a 2821 and 6500 router? Could you provide the commands that need to be entered on the two sides? Are there any gotchas that I should be aware of about l2tp?
08-29-2012 02:04 AM
Hi Kashish,
Please check the link to configure:
L2TP with IpSec
http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080093f6f.shtml
REgards
Please rate if it helps.
08-29-2012 02:11 AM
We don't need ipsec, just plain t2tp tunneling..
Just found that 6500 does not support l2tp, so now we are planning to run the tunnel between 2821 and 3845 routers. Could you please confirm if this setup is possible?
Thanks
08-29-2012 02:36 AM
Hi Kashish,
yES this scenrio will work.
It is alwayas better to use encrypted tunnel to make secure.
Usually we are using gre TUNNELS WITH IPSEC:
Regards
Please rate if it helps.
08-29-2012 02:56 AM
Reason we are not using encrypted tunnels is because the tunnel will be between two departments and will go through internal network only. hence just l2tp should be fine.
08-29-2012 03:45 AM
ok good,
just mark this question as answered...if are please with this.It may helps others.
Regards
please rate if it helps.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: