08-09-2011 06:34 AM - edited 03-04-2019 01:13 PM
Hello Guy's come to a bit of a block in the road on a network im building ,all is going well except i need to build a pseudowire to backup our primary L2 circuit, I labbed this with some 3745's but the kit we are using is the 1921, with the universal image how do i go about upgrading functionality to allow this
Lab Config:
pseudowire-class L2DRPATH
encapsulation l2tpv3
ip local interface Serial0/0
interface FastEthernet1/0
no ip address
speed 100
full-duplex
no cdp enable
xconnect 10.10.10.2 101 pw-class L2DRPATH
but neither
pseudowire-class under configuration mode, or xconnect under interface configuration mode is known.
Good ducmentation for people wanting to do the same:
https://isc.sans.edu/diary.html?storyid=8704
Version :
"usbflash0:c1900-universalk9-mz.SPA.150-1.M5.bin"
Many regards Neil
Solved! Go to Solution.
08-09-2011 10:08 AM
08-09-2011 07:46 AM
You need to purchase the Data+Security license.
Regards,
Edison
08-09-2011 09:11 AM
Thanks for the info, once i get the license can I perform the upgrade from the CLI? is there any useful documentation?
Cheers neil
08-09-2011 10:08 AM
08-10-2011 01:07 AM
Much appricated
Regards Neil
02-03-2015 11:21 PM
Hi
Are you able to configure the command 'pseudowire-class' after upgrading the IOS.
02-03-2015 11:21 PM
Hi Edison
Can you please share document mentioning that 'pseudowire-class' is supported in data + security license in ISR G2 Router.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: