cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
76
Views
0
Helpful
3
Replies
Highlighted
Beginner

L3 switch

Hi,

I am using Cisco 3560 switch as my core switch. Internet is terminating on the firewall (Cyberoam make). Firewall (LAN Port) is connected to 3560 switch and from here to edge switches.

Now I need to MAC bind certain computers in the firewall. But as the L3 switch is coming in between the firewall is not recognizing the computer MAC address.

Is there any way i can do this.

Regards,
Alex George

3 REPLIES 3
VIP Advisor

Hi

Hi

Please correct me if Im wrong, you want only allow certain computers to have internet access? 

I think you could use an extended ACL on the interface vlan used to connect with the firewall in order to allow just desired IP address to get Internet, as the firewall is connected to the LAN port (layer 2 port). Other way is to configure the port as layer 3, it will be your point to point and the ACL will be applied on the port directly. 

The layer 3 switch has a default route pointing to the firewall, right? 

Hope it is useful

:-)

VIP Expert

For your FW to "see" host

For your FW to "see" host MACs, it and they would need to have an interface on the same VLAN.  A 3560 can do this, as L3 switches generally support all L2 switch features.

Hall of Fame Guru

Assuming you have multiple

Assuming you have multiple vlans and you route them on the 3560 then the short answer is no you cannot do it as you have it setup currently.

You would need the firewall in the same vlan as the clients as Joe says but then your 3560 is no longer routing between the clients and the firewall. Difficult to give full options without more details.

Jon

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards