cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
459
Views
1
Helpful
1
Replies

labeled ipv4 and labeled ipv6 option is not feasible in NCS540

Ktry
Level 1
Level 1

Hi,

I have a problem in my NCS540 box.
In my box, labeled are not feasible as follows:
Is there any required package to be activated?

RP/0/RP0/CPU0:NCS(config-bgp)#address-family ipv4 ? (ipv6 is the same)
flowspec Address Family modifier
mdt Address Family modifier
multicast Address Family modifier
mvpn Address Family modifier
rt-filter Address Family modifier
sr-policy Address Family modifier
tunnel Address Family modifier
unicast Address Family modifier

Version is 7.3.2.
Platform is NCS540.

RP/0/RP0/CPU0:NCS(config-bgp)#do sh ver
Tue Oct 3 22:41:51.615 JST
Cisco IOS XR Software, Version 7.3.2
Copyright (c) 2013-2021 by Cisco Systems, Inc.

Build Information:
Built By : ingunawa
Built On : Wed Oct 13 20:17:42 PDT 2021
Built Host : iox-ucs-021
Workspace : /auto/srcarchive17/prod/7.3.2/ncs540/ws
Version : 7.3.2
Location : /opt/cisco/XR/packages/
Label : 7.3.2

cisco NCS-540 () processor
System uptime is 11 hours 30 minutes

RP/0/RP0/CPU0:NCS-183(config-bgp)#do sh platform
Tue Oct 3 22:41:54.552 JST
Node Type State Config state
--------------------------------------------------------------------------------
0/RP0/CPU0 N540-ACC-SYS(Active) IOS XR RUN NSHUT
0/RP0/NPU0 Slice UP
0/FT0 N540-FAN OPERATIONAL NSHUT
0/FT1 N540-FAN OPERATIONAL NSHUT
0/FT2 N540-FAN OPERATIONAL NSHUT
0/FT3 N540-FAN OPERATIONAL NSHUT
0/PM0 N540-PWR400-A OPERATIONAL NSHUT
0/PM1 N540-PWR400-A FAILED NSHUT
RP/0/RP0/CPU0:NCS(config-bgp)#



They're active.

#do sh install active
Tue Oct 3 22:39:53.713 JST
Label : 7.3.2

Node 0/RP0/CPU0 [RP]
Boot Partition: xr_lv68
Active Packages: 9
ncs540-xr-7.3.2 version=7.3.2 [Boot image]
ncs540-ospf-2.0.0.0-r732
ncs540-isis-1.0.0.0-r732
ncs540-k9sec-1.1.0.0-r732
ncs540-mpls-1.0.0.0-r732
ncs540-mpls-te-rsvp-1.0.0.0-r732
ncs540-li-1.0.0.0-r732
ncs540-mgbl-1.0.0.0-r732
ncs540-mcast-1.0.0.0-r732

Node 0/0/CPU0 [LC]
Boot Partition: xr_lcp_lv69
Active Packages: 9
ncs540-xr-7.3.2 version=7.3.2 [Boot image]
ncs540-ospf-2.0.0.0-r732
ncs540-isis-1.0.0.0-r732
ncs540-k9sec-1.1.0.0-r732
ncs540-mpls-1.0.0.0-r732
ncs540-mpls-te-rsvp-1.0.0.0-r732
ncs540-li-1.0.0.0-r732
ncs540-mgbl-1.0.0.0-r732
ncs540-mcast-1.0.0.0-r732

Any comment would be highly appreciated.

Regards,

1 Reply 1

Ktry
Level 1
Level 1

Sorry.  Self-resolved. I was trying to configure in the wrong context.
I close this post. 
Regrads,

(config-bgp-nbr)#address-family ipv4 ?
flowspec Address Family modifier
labeled-unicast Address Family modifier
mdt Address Family modifier
multicast Address Family modifier
mvpn Address Family modifier
rt-filter Address Family modifier
sr-policy Address Family modifier
tunnel Address Family modifier
unicast Address Family modifier