layer 2 and layer 3 vpn

[dannymcca]

Hi,

i am trying to set up a vpn that will pass both layer 2 and layer 3 traffic.

i have 2 887VA routers and these communicate via adsl lines. They are currently passing layer 3 traffic without any issues and i have used an IPSEC-ISAKMP security.

It has been some years since i did my CCNA and am therefore very rusty and would appreciate as much help as you can give.

Many thanks

[Jeff Van Houten]

You might want to look at l2tp instead of IPSec.

Sent from Cisco Technical Support iPad App

[dannymcca]

i have looked for a sample l2tp configuration but most use pppoe whereas my connection is over adsl using ppoa.

i currently have a working vpn using ipsec/isakmp is there a simply way to enable this to use l2tp protocol?

my current config is attached.

thanks for your help.