cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
15481
Views
15
Helpful
5
Replies
Highlighted
Beginner

License Activation on 4500

HI all,

 

  I want to use this (entservices) its showing active but not in use how can i do that ?

 

CORE1#sh license summary 
Index 0   Feature: entservices
          Period left: 1513 weeks 1 day 
          License State: Active, Not in Use, EULA accepted
          License Count: Non-Counted
Index 1   Feature: ipbase
          Period left: 8 weeks 4 days 
          License Type: Evaluation
          License State: Active, Not in Use, EULA not accepted
          License Count: Non-Counted
          License Priority: None
Index 2   Feature: lanbase
          Period left: 0 seconds
Index 3   Feature: internal_service
          Period left: 0 seconds

===============================================

CORE1#sh license right-to-use 
License Store: Primary License Storage
License Store: Dynamic License Storage
StoreIndex: 1 Feature: entservices  Version: 1.0
      License Type: PermanentRightToUse
      License State: Active, Not in Use, EULA accepted
      License Count: Non-Counted
StoreIndex: 3 Feature: ipbase  Version: 1.0
      License Type: PermanentRightToUse
      License State: Inactive
      License Count: Non-Counted

=======================================================

CORE1#sh license all 
License Store: Primary License Storage
License Store: Dynamic License Storage
StoreIndex: 0 Feature: entservices  Version: 1.0
      License Type: Evaluation
        Evaluation total period: 8 weeks 4 days 
        Evaluation period left: 8 weeks 3 days 
      License State: Inactive
      License Count: Non-Counted
      License Priority: Low
StoreIndex: 1 Feature: entservices  Version: 1.0
      License Type: PermanentRightToUse
      License State: Active, Not in Use, EULA accepted
      License Count: Non-Counted

StoreIndex: 2 Feature: ipbase  Version: 1.0
      License Type: Evaluation
        Evaluation total period: 8 weeks 4 days 
        Evaluation period left: 8 weeks 4 days 
      License State: Active, Not in Use, EULA not accepted
      License Count: Non-Counted
      License Priority: None
StoreIndex: 3 Feature: ipbase  Version: 1.0
      License Type: PermanentRightToUse
      License State: Inactive
      License Count: Non-Counted

============================================

CORE1#sh version 
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSAL-M), Version 03.04.02.SG RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2013 by Cisco Systems, Inc.
Compiled Thu 05-Sep-13 20:34 by prod_rel_team

 

Cisco IOS-XE software, Copyright (c) 2005-2010, 2012 by cisco Systems, Inc.
All rights reserved.  Certain components of Cisco IOS-XE software are
licensed under the GNU General Public License ("GPL") Version 2.0.  The
software code licensed under GPL Version 2.0 is free software that comes
with ABSOLUTELY NO WARRANTY.  You can redistribute and/or modify such
GPL code under the terms of GPL Version 2.0.  For more details, see the
documentation or "License Notice" file accompanying the IOS-XE software,
or the applicable URL provided on the flyer accompanying the IOS-XE
software.

 

ROM: 15.0(1r)SG5
CORE1 uptime is 1 day, 1 hour, 4 minutes
Uptime for this control processor is 1 day, 1 hour, 7 minutes
System returned to ROM by power-on
Running default software
Jawa Revision 7, Snowtrooper Revision 0x0.0x1C

Last reload reason: power-on

 

License Information for 'WS-X45-SUP7-E'
    License Level: lanbase   Type: Default. No valid license found.
    Next reboot license Level: lanbase

cisco WS-C4507R+E (MPC8572) processor (revision 10) with 2097152K/20480K bytes of memory.
Processor board ID FXS1650Q0US
MPC8572 CPU at 1.5GHz, Supervisor 7
Last reset from PowerUp
8 Virtual Ethernet interfaces
144 Gigabit Ethernet interfaces
4 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.

Configuration register is 0x2101

CORE1#

 

 

5 REPLIES 5
Beginner

Hi ,

Hi ,

Please issue the below command to activate the ent feature.

Switch# license right-to-use activate entservices all acceptEULA

 reload.

 

and then check

Don't you have set it as the

Don't you have set it as the next license boot level before reload?

Switch(config)# license boot level entservices
Beginner

I didnt have to do that, just

I didnt have to do that, just:

license right-to-use activate entservices acceptEula

wr

reload

Enthusiast

Re: Don't you have set it as the

I had to do this.

Re: Don't you have set it as the

I'm upgrading from single SUP6 entservices to dual SUP7.

 

after entering "license right-to-use activate entservices acceptEULA" and reload, using IOS-XE 3.8.8, I still have no licenses activated.

 

Switch#sh license all
License Store: Primary License Storage
License Store: Dynamic License Storage
StoreIndex: 0 Feature: entservices Version: 1.0
License Type: Evaluation
Evaluation total period: 8 weeks 4 days
Evaluation period left: 8 weeks 3 days
License State: Active, Not in Use, EULA accepted
License Count: Non-Counted
License Priority: Low
StoreIndex: 1 Feature: entservices Version: 1.0
License Type: PermanentRightToUse
License State: Inactive
License Count: Non-Counted
StoreIndex: 2 Feature: ipbase Version: 1.0
License Type: Evaluation
Evaluation total period: 8 weeks 4 days
Evaluation period left: 8 weeks 4 days
License State: Active, Not in Use, EULA not accepted
License Count: Non-Counted
License Priority: None
StoreIndex: 3 Feature: ipbase Version: 1.0
License Type: PermanentRightToUse
License State: Inactive
License Count: Non-Counted
StoreIndex: 4 Feature: lanbase Version: 1.0
License Type: PermanentRightToUse
License State: Active, Not in Use, EULA not accepted
License Count: Non-Counted

Switch#
Switch#sh license right-to-use
License Store: Primary License Storage
License Store: Dynamic License Storage
StoreIndex: 1 Feature: entservices Version: 1.0
License Type: PermanentRightToUse
License State: Inactive
License Count: Non-Counted
StoreIndex: 3 Feature: ipbase Version: 1.0
License Type: PermanentRightToUse
License State: Inactive
License Count: Non-Counted
StoreIndex: 4 Feature: lanbase Version: 1.0
License Type: PermanentRightToUse
License State: Active, Not in Use, EULA not accepted
License Count: Non-Counted

Switch#

show license in-use returns nothing.

 

if it set :

Switch(config)# license boot level entservices

Then entservices is activated but as Evaluation.

 

After a couple of reboot and tests I didn't manage to get the permanent entservices.

 

Any clue ?

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards