- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2011 07:49 PM - edited 03-04-2019 12:00 PM
Hi All,
We have this network (please refer to the attached file) which I want to configure loadbalance and failover on the remote site using EIGRP. How can this be done? Please note that links on the remote sites has different bandwidth.
Your help is much appreciated.
Regards,
cmadiam82
Solved! Go to Solution.
- Labels:
-
Routing Protocols
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2011 09:24 PM
Hi,
On the remote side router make sure the bandwidth and the delay commands should have the same value on both the wan interfaces.
I have tested on my GNS3, you can find attached the sample configuration for your reference.
Thanks
Karuppu
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2011 09:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2011 09:51 PM
Thanks a lot Karuppu!!!
