cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
476
Views
0
Helpful
1
Replies

Load Balancing 2 ISP connections on Cisco Router

Hi all,

I have a Cisco 3900 series Router with the following characteristics:

Cisco IOS Software, C3900 Software (C3900-UNIVERSALK9-M), Version 15.0(1)M2, RELEASE SOFTWARE (fc2)

 

I have two VDLS connections, my ISP cant really offer good speeds, so we have two connections of 3Mb/s each. (2x3Mbps).

Each link has its own modem and we get a /29 on each connection.

 

I have setup NAT on the router, but i am trying to use BOTH connections simultaneously. This is causing an issue for me. At the moment i am not able to use one of the connections for some reason.

I have re-created the very same scenario i have LIVE at the moment, in packet Tracer.

NOTE: uploading .pkt files is not allowed here, so i have uploaded it to http://192.210.197.186/DUAL_NAT.pkt

When trying to ping from one of the computers in the LAN (192.168.1.0/24) to a Loopback address on Router 4 ( 31.7.57.1) for example, i have 50% packet loss. I assume this is because one 50% of the packets are being routed via each connection.

 

Is there a practical way to solve this?

 

Please note that i am using the same NAT statements in both interfaces connected to the ISP, same ACL for the NAT statements as well.

 

Any advise is appreciated.

 

Ezequiel

Everyone's tags (3)
1 REPLY 1
Highlighted

An additional Note: The PKT

An additional Note: The PKT Lab was done with the Packet Tracer Student Version, not the normal packet tracer version. Anyone yet?

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards