01-30-2020 09:23 AM
Hello
I need to configure a load balancing and fault tolerance towards two devices.
OSPF can be configured in this device; VRRF or static.
What advice do you give me?
Thank you
01-30-2020 09:37 AM
01-30-2020 10:44 AM
So if I configure the same OSPF cost the load balancing happens per packet or flow?
01-30-2020 05:06 PM
01-30-2020 10:52 PM
so can I get the same result with static routes?
01-31-2020 01:06 AM
What devices are A and B ? (Cisco) routers ?
01-31-2020 02:34 AM - edited 01-31-2020 02:41 AM
Hello
@vin.marco wrote:
so can I get the same result with static routes?
Yes it can, by default if you have two equal cost static routes then per-destination load balancing would work however you would need to apply some monitoring( ip sla tracking) of those static routes in case of upstream failure so either are removed if the destination isn’t available basically tuning them into floating static routes, alternatively you could use policy based routing with ipsla with the statics.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide