06-16-2022 09:09 AM
I'm trying to ping L0 on Core1 but it's not working! I tried everything but I don't understand the reason why
VPC6 and 5 are able to ping everything in this network except L0 on Core1
06-16-2022 10:12 AM
Hi
Your access switch is doing layer 3, right? Are you using Dynamic protocol? Which one?
show ip route on the Access switch does it show the L0 ip address?
06-16-2022 11:35 AM
Hello,
if possible, post the full running configs (sh run) of all three switches, as well as of the router...
06-16-2022 12:12 PM
any redistribution happening with Dynamic protocols if you are running them? Any Route-map preventing it?
06-16-2022 12:49 PM
Hi,
can I see output
trace route Lo core 1
06-16-2022 01:40 PM - edited 06-16-2022 01:40 PM
Hello
Not enough information however It sounds like the loopback address(s) are not being advertised so the vpcs hosts are able to reach them.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide