I'm doing EVC and QinQ testing with ME3600, Cat3560 and some Routers.
Refer to the uploaded test diagram, found "%SW_MATM-4-MACFLAP_NOTIF: Host 0021.a06a.488c in vlan 500 is flapping between port Fa0/11 and port Fa0/16" keeps appearing in the console.
At the beginning, R1 can ping R3 and R4, and R2 also can ping R3 and R4. But after few minutes, they no longer can ping each other.
I tried to disable l2protocol-tunnel stp, R1 can resume ping to R3 and R4 now but it cannot ping in first 2-3 packets at the beginning then resume and after around 1000 pings, it will have 2-3 packet loss and resume again.
Also, the vlan flapping of s-tag 500 still appeared at SW1. I have tried to disable the spanning tree on vlan 500 but problem still exists
Cisco Digital Network Architecture Center Tools <Template Editor > In this article, we are going to talk about the Cisco Digital Network Architecture Center Template Editor tool.Cisco DNA Center gives us the flexibility and scalability to confi...
Community Live- Cisco SD-WAN Policies: Leveraging the Full Power of Cisco SD-WAN
(Live event - formerly known as Webcast- Tuesday 24 March, 2020 at 10 am Pacific/ 1 pm Eastern / 6 pm Paris)
This event had place on Tuesday 24th, March 2020 at 10hrs P...
IS there a way to upgrade the ios on a cisco 9200l switch using a usb drive instead of using a tftp server? If so could someone point me to the article or tell me how this can be done? These switches seem to be more complicated than previous switches. Tha...
Hello,I'm needing to integrate the Cisco Firepower 2110 into our Data Center JUST to fulfill Site-to-Site and Remote Access VPN. My SD-WAN ISRs already have FW and IPS running, which is what I want since I have internet breakouts at my branches, so this D...
Hi, Switch 1 and switch 2 connected via trunk. Both configured with new vlan 3.When creating new vlan 3, is it need to include "Spanning-tree vlan 3 priority 8192"- Sw 1 and "Spanning-tree vlan 3 priority 16384"-Sw 2?What will happen for those s...