Hi,
I have a small doubt regarding NAT ACL. Below is my config sample. When traffic initiated from 10.10.10.1 to 172.16.1.1, no translation happening due to ACL 200 being get hit. Is this a normal behavior of NAT? Do we have any documentation regarding this ACL conflict?
ip access-list extended 100
permit ip 10.10.10.0 0.0.0.255 172.16.1.0 0.0.0.255
ip access-list extended 200
permit ip 10.0.0.0 0.255.255.255 172.16.0.0 0.0.255.255
route-map CONDITION
match ip address 200
ip nat pool ABC 50.50.50.1 50.50.50.1 netmask 255.255.255.0
ip nat inside source list 100 pool ABC overload
ip nat inside source static 10.10.10.2 2.2.2.2 route-map CONDITION
Regards,
Godwin. S