Gents
we have a cisco 2800 series router which is connected to 2960 layer two switch couple of servers are connected to the layer two switch. I have notised that there is nat statement on the interface of the router which is connected to the layer two switch saying ip NAT inside and then there is couple of nat statement one to one in the router.
recently we have decided that we should remove the switch as the number of servers were reduced to three. I have bought a layer 2 switching module for the router (built-in). I have just realized that how would i now do the NAT??? i am really confused
is there any way (to add more to the misery the WAN connection is ISDN)