NAT - multiple "many to one" for one site

[jkemejuk]

Need help please with a small network for 200 users to access the Internet via 6 static IP addresses provided by the ISP. Switches are 2950T-48, router is an 1841. I'd like to have a separate NAT pool for each switch, each pool pointing to one of the 6 static IPs. Would like to know best way to configure this please.

[mchin345]

NAT only uses access lists and route maps when it needs to create a translation entry. If a translation entry already exists that matches the traffic then the translation entry will be used; any access lists or route maps will not be consulted. The difference between using an access list or route map is the type of translation entry that will be created. For more information:

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a0080093fca.shtml