cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
507
Views
0
Helpful
4
Replies

NAT Port Forward based on public source IP?

Ruud van Strijp
Level 1
Level 1

Hello,

I have one public IP address but multiple local servers that run on the same port. I cannot change the port the clients use to connect to this server, so I can't do a port map in my NAT router. The solution I had in mind, is to filter on source address. If a client from public IP X.X.X.X connects to port Z, I want it to go to internal server 10.10.10.10 and if a client from public IP Y.Y.Y.Y connects to port Z, I want it to go to internal server 10.20.20.20. Is this possible?

Thanks,

Ruud van Strijp

4 Replies 4

Hi Ruud,

Are you planning to do this on Firewall or Router ?

I'm not too sure about this on Cisco Routers, but I think I have seen something like this on Cisco's cheif compititor (just that I don't want to take the name of the vendor )

Regards,

Smitesh

fb_webuser
Level 6
Level 6

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t4/feature/guide/ftnatrt.html no sure but try this

---

Posted by WebUser Nika Pitskhelauri

Ruud van Strijp
Level 1
Level 1

Thanks for your replies. I am trying to do this with an ASA5510 or ASA5505. Would that be possible?

Hi Rudd,

On Firewall it should work (although, I'm not good at firewall); but I'm saying this because of the fact that firewall keep session information (though now a days higher end router also do same) also.

I suggest to post thiss query in Firewall under Security forums.

Regards,

Smitesh

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco