cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
271
Views
0
Helpful
1
Replies

Need Help configuring WIC-1AM for remote access

fast5658659
Level 1
Level 1

Hi guys, we have configured WIC-1AM card on cisco 2900 series router please find the config below

!

interface Async0/0/0

ip address negotiated

encapsulation ppp

dialer in-band

dialer string 61398016923

dialer-group 1

async mode dedicated

no keepalive

line 0/0/0

modem InOut

transport input all

transport output all

autoselect arap

stopbits 1

speed 115200

flowcontrol hardware

When we try to dial in to remotely access the router we get the attached error

Please advise if there is anything missing in the config

1 Reply 1

Kevin P Sheahan
Level 5
Level 5

Looks like the type of garbled output you'd see from having the wrong baud rate. Try setting the speed for 'line 0/0/0' to 33600. 115200 is well over the 56k capabilities of V.90 connections. What type of connection do you have?

Kind Regards,

Kevin

**Please remember to rate helpful posts as well as mark the question as 'answered' once your issue is resolved. This will help others to find your solution faster.

Kind Regards, Kevin Sheahan, CCIE # 41349
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: