10-09-2014 01:19 PM - edited 03-04-2019 11:56 PM
Hi Guys,
I have one question about Network design. We have two datacenter Primary and secondary. we advertised same subnet from Primary and secondary data center but from secondary DC we advertised these subnet with 2 times as prepend so the remote branches which are connected via Service provider using BGP MPLS will always preferred Primary DC. But now we have requirement that one branch will always prefer secondary DC and other braches always prefer Primary DC. What we should do for it
10-09-2014 10:21 PM
Hello
Since you are going through SP MPLS, you have lesser control on outbound route selection..Your traffic will always go to the PE where you have connected. I believe the easiest way to do this with the coordination with Service provider as they have better control for the advertised routes
Harish.
10-16-2014 01:10 AM
Hi,
You must have taken L3VPN service from service provider. On PE router service-provider needs to apply import route-map to increase LP of the preferred DC site.
Regards,
Akash
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide