12-10-2011 02:10 PM - edited 03-04-2019 02:35 PM
Hi Team
I have my DMVPN setup , and i can see my hub from my two spokes and specially my dynamic NHRP mapping is working great in the hub where i can see both spoke but not on the spokes, i only have the dynamic mapping for the hub
I want spoke to spoke traffic to use your NMBA tunnel when there is traffic need to go from spoke to spoke but i can`t do that since NHRP is not mapping my spokes IP on the table (dynamically) and i tried to do statically but it`s not working!
ANy help please ?
12-10-2011 02:51 PM
Hi,
Have a look this document for config example and explanation:
http://blog.ine.com/2008/08/02/dmvpn-explained
HTH
12-11-2011 04:20 AM
What routing protocol are using ?
Can you post the hub config
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide