cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
464
Views
0
Helpful
1
Replies

NM-2W and HWIC-4B-S/T

ashley_dew
Beginner
Beginner

Hi,

I wanted to confirm if NM-2W supports HWIC-4B-S/T in the WAN slots.

I have conflicting information:

On NM-2W says that it does not support HWIC modules or the module.

http://www.cisco.com/en/US/customer/prod/collateral/routers/ps259/product_data_sheet09186a00801aa71c.html

On specs of the ISDN card, it says

Supported in NM-1FE2W-V2, NM-1FE1R2W, NM-2FE2W-V2, and NM-2W

Can not be inserted into a mixed-media network module

http://www.cisco.com/en/US/prod/collateral/modules/ps5949/data_sheet_c78_439536.html

I am kind of confused.

Can you please assist or anyone had an experience installing these cards on a NM-2W

Thanks,

Ashley

1 Reply 1

mvsheik123
Rising star
Rising star

Hi Ashley,

No. It does not supported on NM-2W. Please see the note at the beginning of table 2 in the below link..

http://www.cisco.com/en/US/partner/docs/routers/access/interfaces/nm/hardware/installation/guide/OvrNetM.html

(High-density WAN interface cards (HWICs) are not supported on 1- or 2-slot network modules).

With ref to the second link in your posting- The ISDN card specs comparing the NM-4B-S/T (supported by NM-2W) and HWIC-4B-S/T.

hth

MS

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers