No Auto Summary Not Saved in 3650_24PS

[drushka]

Hi,

In Packet Tracer, I’m using a Layer 3 switch (3650_24PS) with OSPF configured. When I enter the command no auto-summary and save the configuration using either write memory or copy running-config startup-config, the setting is lost after a restart of Packet Tracer. The no auto-summary command is deleted upon reboot. Please Help

Thank you!

[MHM Cisco World]

It not delete 

It run by defualt that why it not appear 

Try use 

Show run all 

To see this command and othet defualt command 

MHM

[Flavio Miranda]

@drushka 

 There is no "no auto-summary" command on 3650 in PacketTracer. You can see this command in EIGRP.

Those are the options.

area OSPF area parameters

auto-cost Calculate OSPF interface cost according to bandwidth

default-information Control distribution of default information

distance Define an administrative distance

exit Exit from routing protocol configuration mode

log-adjacency-changes Log changes in adjacency state

neighbor Specify a neighbor router

network Enable routing on an IP network

no Negate a command or set its defaults

passive-interface Suppress routing updates on an interface

redistribute Redistribute information from another routing protocol

router-id router-id for this OSPF process

[drushka · Accepted solution]

sorry meant eigrp making new post