cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5223
Views
1
Helpful
1
Replies

NSR disabled on neighbor due to TCP retransmissions

hatman
Level 1
Level 1

Hello,

I have a problem on ASR9K routing, i found this log on ASR9K , am not sure about the meanning of this ?

but i found the route record are slowly update to our routing table.

I hope you give me your recommendation for this problem.

Thanks in advanced.

%ROUTING-BGP-3-INITSYNC_PFX_MISMATCH : Neighbor: x.x.x.x State: Idle Flags: 0xa310000 vrf: default AFI: IPv4 Unicast Pfx received: 5230843 expected: 423616 - will retry once more

%ROUTING-BGP-3-NBR_NSR_DISABLED : NSR disabled on neighbor x.x.x.x due to Standby reset

%ROUTING-BGP-5-NBR_NSR_DISABLED_STANDBY : NSR disabled on neighbor x.x.x.x on standby due to Peer closing down the session (VRF: default)

%ROUTING-BGP-3-NBR_NSR_DISABLED : NSR disabled on neighbor x.x.x.x due to TCP retransmissions

%IP-TCP_NSR-5-DISABLED : y.y.y.y:41576 <-> x.x.x.x:179:: NSR disabled for TCP connection because Retransmission threshold exceeded

1 Reply 1

samitjana
Level 1
Level 1
Had same issue in 6.5.3 version as well in NCS
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card