cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
3991
Views
0
Helpful
20
Replies
Beginner

Re: OTV on DMVPN

I had DMVPN running OTV. I did it two ways. I put the join interface on a loopback and used pim sparse/pim nbma and also tried with pim dense on the tunnel. It worked well (caveat at the bottom)

The second set of configs had the join interface set as the tunnel (caveat at the bottom).

In all instances I had to manually add an "ip igmp join x.x.x.x" for the control group on the join interface. This pops in a CLNS duplicate system ID message. All I did was add a logging discriminator to ignore those messages.

We had to abandon OTV since it requires that all clients support SSM. Since multicast relies on igmp snooping it does not work with ssm static mappings.

Beginner

Re: OTV on DMVPN

can you share your latest configuration?

Cisco Employee

Re: OTV on DMVPN

Hi,

Even though this post is quiet old, I just to add one small information here, as of today there is no formal support to use logical interfaces as a join-interface [in ASR1K]. So, the solution if you cannot have a multicast-core is to go for unicast usage of OTV [adjacency server usage]

Beginner

Re: OTV on DMVPN

How about you try running OTV with adjacency server instead ? Available with 5.2 and no need for multicast in the core/backbone

Sent from Cisco Technical Support iPhone App

Beginner

Re: OTV on DMVPN

How about you try running OTV with adjacency server instead ? Available with 5.2 and no need for multicast in the core/backbone.

Sent from Cisco Technical Support iPhone App

Highlighted
Cisco Employee

Re: OTV on DMVPN

Sorry for the delay in getting back to you guys, but I just came across this post. As of IOS XE3.10, using a GRE Tunnel as a join interface is not supported on ASR1000. The join interface must be a POS interface, GigE interface, GigE sub-interface, Port-channel interface, or Port-channel sub-interface.  While you may be able to configure a GRE tunnel interface as the join interface and have it work successfully, it is not an officially supported configuration.  This is due to the fact that we need to be able to detect all conditions where an OTV router looses connectivity to the other OTV routers via the join interface.  We can do this for the interface types listed but not for the logical interfaces (including Loopbacks, GRE tunnels, etc).

You can however configure GetVPN on the phyiscal join interfaces to provide the encryption,

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards