03-20-2019 04:07 AM
Hi,
I'm having trouble to set up my first Cisco Router RV345. Everything seems to work well but most of the outgoing port seems blocked. I can access every websites but if i want to reach something with a address like XXX.XXX.XXX.XXX:8080 or www.XXXX.com:88 it doesn't work. I tried several port like 6281 for my Synology, it's like the RV345 blocked every port but the 80, 443, 25, 21. I can't find where to unlock that. I tried to create some access list to allow any to any on port 6281 but still no good. Can somebody help me. Thanks.
Solved! Go to Solution.
03-22-2019 01:21 AM
03-20-2019 04:37 AM
Hello,
is the firewall enabled or disabled (page 63 of the attached guide) ?
03-20-2019 08:13 AM
Hi, the firewall is enabled. I have also checked the DoS.
03-20-2019 08:25 AM - edited 03-20-2019 08:26 AM
Hello,
it is difficult to comment on what you might be 'missing'. Are the same sites reachable when you don't specify the port ?
Can you give an example ? It might be that the sites themselves don't like to be addressed with specific ports...
What if you disable the firewall ?
Also, make sure you are running the latest firmware release, 1.0.02.16...
03-20-2019 08:55 AM
It's not about the site. I have several websites i tried. For example, from behind the cisco if i try to reach another external router on a port other than 443 (i change the remote management port to 4430) it won't work. If i change it back to 443, i can reach the router. Or another example, if i try to reach my DVR on an external ip using the port 88 it won't work but work if i change the port of the DVR to 80. I just updated the latest firmware and tried to disable the firewall but nothing change.
03-21-2019 03:14 AM
03-22-2019 01:21 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: