Packet tracer Site to site VPN configuration gone

[Joshua X P]

Hi,

I configured Site to Site VPN in Packet tracer 7.3.0 between two 2901 routers. I Saved the running Conf to startup-config. But When turn OFF and turn ON the physical switch of the router my all VPN configurations are gone in the startup-config. If I reload the router using the Reload command, I'm not facing this issue. And I'm not facing this with 4321 routers.

I believe this could be a bug. Correct me If I'm wrong

Thanks,

Joshua X P

[Georg Pauwen]

Hello,

could be a bug indeed. Can you post the zipped .pkt file ?

[Joshua X P]

Hi Georg,

Thanks for your reply!

Here I attached the Zipped .pkt file

Regards,

Joshua X P

[Georg Pauwen · Accepted solution]

Hello,

same here, so it seems to be a bug indeed. It seems to still be in the startup-config after the power down/up (sh startup-config). If you do a 'copy startup-config running-config' after the powe down/up, it should be back...

[Joshua X P]

Thanks for the solution! 

I hope Cisco would fix this bug in next update.