Pesistent Logging Configuration

[Cisco Freak]

Hello,

I am encountering this error when setting up persistent logging.

switch(config)#logging persistent url ?
disk0: Filesystem name
slavedisk0: Filesystem name
slavesup-bootdisk: Filesystem name
slavesup-bootflash: Filesystem name
sup-bootdisk: Filesystem name
sup-bootflash: Filesystem name
sw1-slot5-disk0: Filesystem name
sw1-slot5-sup-bootdisk: Filesystem name
sw1-slot5-sup-bootflash: Filesystem name
sw2-slot5-disk0: Filesystem name
sw2-slot5-sup-bootdisk: Filesystem name
sw2-slot5-sup-bootflash: Filesystem name

switch(config)#logging persistent url sup-bootdisk:Log
%No "disk0:/sup-bootdisk:Log" installed

Is there a restriction that persistent log can be configured only to disk0?

CF

[Julio E. Moisa]

Hi 

Try with 

logging persistent url sup-bootdisk:/Log 

[Cisco Freak]

It didn't work.

switch(config)#logging persistent url sup-bootdisk:/Log 
%No "disk0:/sup-bootdisk:/Log" installed

[Julio E. Moisa]

Do you see something on that location?

show sup-bootdisk:

or try using the sup-bootflash:

[Cisco Freak]

Again no luck!

show sup-bootdisk and show sup-bootflash list the contents there successfully.

switch(config)#logging persistent url sup-bootflash:/Log
%No "disk0:/sup-bootflash:/Log" installed

switch(config)#logging persistent url sup-bootflash:Log 
%No "disk0:/sup-bootflash:Log" installed

[Cisco Freak]

Any help would be appreciated!

[Georg Pauwen]

Hello,

on a side note, did you configure 'logging buffered' before entering the persistent commands ?

[Cisco Freak]

I did. The device is running buffered logging and remote syslog as well.

[Julio E. Moisa]

what is your IOS?

[Georg Pauwen]

Hello,

it might be that your platform (which is your platform ?) does not allow writing to sup. Does the below work ?

logging persistent url disk0:/syslog size 134217728 filesize 16384