05-31-2020 06:11 AM
Hi,
i got Cisco C1111-8PLTELAWZ router on 4G LTE.
Currently, its connected with Band 7 (2600MHz) . How to force router to use Band 28 (700MHz).
Also, how to enable Carrier Aggregation on LTE?
Thanks
05-31-2020 12:46 PM
Hello,
I think you have to change your modem settings to:
C1111#cellular 0/2/0 lte technology auto
06-01-2020 04:27 AM
George,
Thanks fro the reply.
i am using that config. but, its giving priority to Band 7.
06-03-2020 12:38 AM
hi,
i found the solution.
actual solution is on IOS XE 16.10 and after release.
show cellular X/Y/Z radio band
And you’ll see the supported bands with its corresponding index number.
In order to force the modem to select a specific band issue the following commands:
config term
controller cellular interface X/Y/Z
lte modem band-select band-indices “Index number”
end
On other devices the option of "band-indices" is not available so we can use the command:
lte modem band-select indices [band]
04-21-2021 08:20 PM
This only works on IOS-XE. C900 series uses IOS which apparently doesn't support the commands above.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: